Power Racing Series Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Bumblebee ======

LVL1 Hackerspace, in Louisville KY, Raced a 'new' kart for the 2017 season.

The SOP for PPPRS at LVL1 is cannibalizing the previous year's build to provide cheap materials for the next year's kart. The frame from the RoomBAMF from 2016 became the frame for the Firetruck reboot in Detroit 2017, which became the frame for Bumblebee, which debuted at Milwaukee 2017.

  * a pic of the roomBAMF: https://www.flickr.com/photos/raster/28288811983/in/album-72157671383753612/
  * a pic of the firetruck: https://www.flickr.com/photos/lvl1/36934245302/
  * a pic of Bumblebee: https://www.flickr.com/photos/lvl1/37065350091/
  * sneak peek pic of the as-yet-unnamed 2018 season car: https://www.flickr.com/photos/lvl1/36498591374/

===== Build Info =====

==== Batteries ====
  *6x Sealed Lead-Acid batteries salvaged used from a UPS battery backup for a commercial server warehouse.
  *Only 3 batteries were used in the vehicle at one time, the other three were on the charger
  *Nominal 36VDC

==== Brakes ====
  * mechanical drum brakes.
  * Home-made break pedal, tensioning and tension distribution apparatus.
  *  Basically the brake line runs from the pedal to the block of a pulley, and the two drum brakes (on on each rear wheel) are tied together on a separate brake line that is fed through that pulley, so the pulley automatically distributes the force from the pedal equally to both drums.
  * lines and electronic trigger for brake lights salvaged from electric Razor scooter.

==== Frame ====
  * Welded metal frame with a thin sheet metal skid plate.

==== Bumpers ====
  * 2x4 pounded onto two iron pipe posts in the front
  * curved metal welded to the frame, with pool noodle around it in the back.

==== Gears & Chain ====
  * idk like #35 or #40. big-ass sproket on each rear wheel (dead rear axle) and very small sproket on each motor.

==== Kill Switch ====
  * Standardized as required by PPPRS regulation

==== Motors ====
  *  2X 800 Watt Scooter Motors

==== Motor Controllers ====
  * 2X 800 Watt Scooter Motor Controllers
  * Motor and Motor Controller sold as a set on amazon; 2X the set was purchased.
  * Adafruit 5v Trinket AnalogReads the potientiometer connected to the 'gas' pedal
  * 'gas' pedal salvaged from "video game controller" like for a driving game with a gas and brake pedal.
  * Trinket 'Analog Writes' PWM shifted output voltage to both of the  

==== Wheels ====
  * The rear wheels are quite a bit bigger than the front wheels.
  * Front wheels were the cheap harbor freight ones that always break. they broke multiple times and are now re-enforced through some sort of means.

==== Wiring and Connectors ====
  * Scrap extension cords, were used for signal-level connections
  * "Noodle Cable" and some sort of recommended connector was used for the power-level connections. (name?)
Power Racing Series Wiki

User Tools

Site Tools

Page Tools
